indigo

Dyeing for Dummies: Natural Dye Poster Child-Indigo

Indigo has a long standing history of heavy-duty power in terms of economics and trade and is probably one of the most talked and written about dyes in the natural dye world.

We love the color blue and all its moodiness. It’s also very in for fall 14. Get ready for the navy explosion!

For this Dyeing for Dummies, I have put not only myself but husband and daughter in the cross hairs of looking foolish, over exuberant, and dummy-like. (Side note, they had a blast and refuse to be called dummies.)

We used all of Botanical Colors’ dyes and ingredients to make Michel Garcia’s 1-2-3 Vat, making mistakes along the way but then, I have Kathy Hattori’s direct line for questions so why freak out?

indigo dyeing 8

Michel Garcia’s Easy Organic Sugar Vat (1-2-3 Vat)

Note:  All of these ingredients may be purchased as a kit or purchase indigo, fructose and calcium hydroxide separately.

indigo dyeing 10

  • 1 part powdered natural indigo
  • 2 parts calcium hydroxide, also known as pickling lime
  • 3 parts fructose crystals

Create your stock in a large 2 quart Mason jar or a sturdy plastic container.

You will be adding hot water, so make sure the plastic is heat resistant. We made our stock with 100 grams (approx. 3.5 ounces) of indigo in a 2 quart Mason jar, so that is about the correct size. If you are making anything larger than that, you’ll need a larger container to mix the stock.  Of course, the beauty of this recipe is you can use just a spoonful of indigo, two spoonfuls of calcium hydroxide and three spoonfuls of fructose, if you’d like a smaller vat.

Wet out the natural indigo with a little warm water to form a paste.

Add about  2 cups of warm tap water (120°F or 50°C) and stir.  The solution will be dark blue and a bit gritty.

Carefully add the calcium hydroxide and stir well. Work out any lumps but try not to beat it so much that you add a lot of air into the solution.  If the mixture gets thick and sticky, carefully add more water to loosen the mixture.

Add the fructose crystals and stir well.

Top off the jar with additional warm water once the calcium hydroxide is incorporated.

indigo dyeing 11

The solution should now look greenish yellow and somewhat murky. Let this settle for an hour. The chemical reaction will work more quickly if the solution is warm, so you can place the glass jar in a pot of hot water.

Stir the solution every 15-20 minutes and let it settle.  Observe the stock and you can see the liquid near the top is getting clearer and yellow-green – Kathy says “Don’t worry if it turns brownish red, that’s okay too.”

After 45 minutes have elapsed, give the stock a final stir and let it settle for 15 minutes.

How to tell if it’s ready…

There’s a nice dark blue indigo flower on the top of the jar of solution and a layer of coppery scum as well.

indigo dyeing 7

There’s a clear demarcation between the liquid in the vat and the layer of sludge below

The color is a yellowish green (it will look somewhat opaque – different than the startling clearness of a chemical vat).

Preparing the Indigo Vat

Fill a non-reactive dye pot about 2/3 full with hot water – approximately 120F.

Carefully tip in the contents of the stock solution including the sludge at the bottom. Stir gently and allow the vat to come to a yellow-green color (this takes between 15-30 minutes). Note:  if you have used the entire 100 gram packet of indigo, you will have a very strong vat.  It’s okay to stir the stock solution and just add a portion of it to the dye pot, too.

Prepare Fabric

All fibers should be thoroughly soaked (wetted out) in lukewarm water prior to dipping.

We went real classy and used our old beach cooler.

indigo dyeing 4

When you see that the vat has become yellowish-green and there’s a blue flower and some coppery scum on top, the vat is balanced and ready for dipping.

We attacked our closets after we saw how much dye we had (we truly could have used less), pulling all sorts of clothes and threw them into the vat.

Kathy says to keep fabrics submerged for 30 seconds to 3 minutes. We went for the full three.

Carefully remove the fiber. You will begin to see the fibers turn from murky green to teal to blue.

This is the magic that all the natural indigo dyers talk about. It really is pretty cool.

indigo dyeing 11 copy

Allow the fiber to turn blue with no teal or yellowish areas.

Let the fiber air for at least 30 minutes, unfolding corners of fabric.

Continue dipping until the fiber is two shades deeper than what you want. As the fiber is rinsed and dried, some of the excess indigo is washed away and the fiber turns out lighter than what you see coming out of the vat. It will also of course lighten up once it dries.

Rebalancing the Vat

The vat will need rebalancing when the dye liquid turns blue. This happened to us and we didn’t have instructions next to us we just said, “Um, this vat is getting weak,” then we referred to these directions.

We reheated the vat gently to 120°F or 50°C and added a generous spoonful of fructose crystals until the vat returned to a yellow-green state.

Kathy had also suggested that if it remains blue, add a level spoonful of calcium hydroxide, stir and wait. We did it. It worked of course because as they say here in Boston, “She’s wicked smaht.”

After a full day of dyeing that even my teenage daughter loved and later, wore her indigo t-shirt to school and even TAGGED me on Facebook to show off her indigo, we were hooked and can’t wait to do it again with a little more experience.

Here are some fun pics from the rest of our day:

indigo dyeing 19

indigo dyeing 15

indigo dyeing 2

indigo dyeing 16

indigo dyeing 18

indigo dyeing 14

indigo dyeing 13

indigo dyeing 17

indigo dyeing 20